What are arduino bords

-
What are Arduino Boards

Image result for simbolo arduino png



Arduino board is an open-source platform used to make electronics projects. It consists of both a microcontroller and a part of the software or Integrated Development Environment (IDE) that runs on your PC, used to write & upload computer code to the physical board.The platform of an Arduino has become very famous with designers or students just starting out with electronics, and for an excellent cause.

Comments

Post a Comment

Popular posts from this blog

Information about H-Bridge

-
Image
Information about H-Bridge H-Bridge module L298N 2A Dual motor driver module with PWM control An H-bridge is a simple circuit that lets you control a DC motor to go backward or forward. You normally use it with a microcontroller, such as an Arduino, to control motors. When you can control two motors to go either forward or backward – you can build yourself a robot! H-Bridge concept Here’s the concept of the H-bridge: A DC motor spins either backward or forward, depending on how you connect the plus and the minus. If you close switch 1 and 4, you have plus connected to the left side of the motor and minus to the other side. And the motor will start spinning in one direction. If you instead close switch 2 and 3, you have plus connected to the right side and minus to the left side. And the motor spins in the opposite direction. The H-Bridge circuit You can build an H-bridge with four transistors. If you’re not sure how the transistor works, I recommend
Read more

How to make Automatic Sanitizer dispenser

-
Image
How to make Automatic Sanitizer dispenser Circuit diagram Components required IR sensor LM293D motordriver Jumper wire Battery Battery cap DC pump Empty container Fuel pipe Zip tie Construction  As we can see in the circuit diagram connect the Vcc pin of IR sensor to 5v of the motordriver. Connect the Digital pin of the IR sensor to the C1-A of the motordriver. Connect the ground pin to the common ground pin of the motordriver. Connect the 9v battery to the motordriver. Connect the DC pump to the M1 pin of the motordriver board.
Read more

Snake game using arduino uno and led dot matrix display MAX7219

-
Image
 Snake game using arduino uno and led dot matrix display MAX7219 Components required Arduino UNO R3 LED dot matrix display MAX7219 Dual axis XY joystick module 10k ohm potentiometer  Bread board  Jumper wire Circuit diagram Connections Connect the +5v  and GND pin of the joystick to 5v and GND pin of arduino. Connect the VRX and VRY pins of joystick to A1 and A2 pin of arduino . Connect the Vcc and GND pins of LED display to 5v and GND pins of arduino. Connect the DIN, CS & CLK PIN OF LED display to 12, 11 &10 pins of arduino. Connect the 1st fixed end of the POT to the 5v pin of arduino and 2nd fixed end to GND of arduino. Connect the variable end of POT to the A5 pin of the arduino. CODE #include "LedControl.h" // LedControl library is used for controlling a LED matrix. Find it using Library Manager or download zip here: https://github.com/wayoda/LedControl // --------------------------------------------------------------- // // ------------------------- user config
Read more